Brocade TurboIron 24X Series Configuration Guide - Manual (Page 62)

28 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Configuring basic system parameters
TurboIron(config)#interface ethernet 4
TurboIron(config-if-e10000-4)#ip address 10.157.22.110/24
TurboIron(config-if-e10000-4)#exit
TurboIron(config)#ip telnet source-interface ethernet 4
Cancelling an outbound Telnet session
If you want to cancel a Telnet session from the console to a remote Telnet server (for example, if the
connection is frozen), you can terminate the Telnet session by doing the following.
1. At the console, press Ctrl+^ (Ctrl+Shift-6).
2. Press the X key to terminate the Telnet session.
Pressing Ctrl+^ twice in a row causes a single Ctrl+^ character to be sent to the Telnet server. After
you press Ctrl+^, pressing any key other than X or Ctrl+^ returns you to the Telnet session.
Specifying a Simple Network Time Protocol (NTPv4) server
You can configure the device to consult NTPv4 servers for the current time and date.
NOTE
TurboIron X Series devices do not retain time and date information across power cycles. Unless you
want to reconfigure the system time counter each time the system is reset, Brocade recommends
that you use the NTPv4 feature.
To identify an NTPv4 server with IP address 10.99.8.95 to act as the clock reference for a device,
enter the following.
TurboIron(config)#sntp server 10.99.8.95
Syntax: sntp server <ip-addr> | <hostname> [<version>]
The <version> parameter specifies the NTPv4 version the server is running and can be from 1 – 4.
The default is 1. You can configure up to three NTPv4 servers by entering three separate sntp
server commands.
By default, the device polls its NTPv4 server every 30 minutes (1800 seconds). To configure the
device to poll for clock updates from a NTPv4 server every 15 minutes, enter the following.
TurboIron(config)#sntp poll-interval 900
Syntax: [no] sntp poll-interval <1-65535>
To display information about NTPv4 associations, enter the following command.
Syntax: show sntp associations
The following table describes the information displayed by the show sntp associations command.
TurboIron#show sntp associations
address ref clock st when poll delay disp
~10.95.6.102 0.0.0.0 16 202 4 0.0 5.45
~10.95.6.101 0.0.0.0 16 202 0 0.0 0.0
* synced, ~ configured