Brocade TurboIron 24X Series Configuration Guide User Manual
Page 273
Brocade TurboIron 24X Series Configuration Guide
239
53-1003053-01
RMON support
Syntax: show rmon statistics
The
SNMP port number. The SNMP numbers of the ports start at 1 and increase sequentially.This
command shows the following information.
TABLE 49
Export configuration and statistics
This line...
Displays...
Octets
The total number of octets of data received on the network.
This number includes octets in bad packets. This number does not include framing bits
but does include Frame Check Sequence (FCS) octets.
Drop events
Indicates an overrun at the port. The port logic could not receive the traffic at full line
rate and had to drop some packets as a result.
The counter indicates the total number of events in which packets were dropped by the
RMON probe due to lack of resources. This number is not necessarily the number of
packets dropped, but is the number of times an overrun condition has been detected.
Packets
The total number of packets received.
This number includes bad packets, broadcast packets, and multicast packets.
Broadcast pkts
The total number of good packets received that were directed to the broadcast
address.
This number does not include multicast packets.
Multicast pkts
The total number of good packets received that were directed to a multicast address.
This number does not include packets directed to the broadcast address.
CRC alignment errors
The total number of packets received that were from 64 – 1518 octets long, but had
either a bad FCS with an integral number of octets (FCS Error) or a bad FCS with a
non-integral number of octets (Alignment Error).
The packet length does not include framing bits but does include FCS octets.
Undersize pkts
The total number of packets received that were less than 64 octets long and were
otherwise well formed.
This number does not include framing bits but does include FCS octets.
Fragments
The total number of packets received that were less than 64 octets long and had either
a bad FCS with an integral number of octets (FCS Error) or a bad FCS with a
non-integral number of octets (Alignment Error).
It is normal for this counter to increment, since it counts both runts (which are normal
occurrences due to collisions) and noise hits.
This number does not include framing bits but does include FCS octets.
TurboIron#show rmon statistics
Ethernet statistics 1 is active, owned by monitor
Interface 1 (ifIndex 1) counters
Octets 0
Drop events 0 Packets 0
Broadcast pkts 0 Multicast pkts 0
CRC alignment errors 0 Undersize pkts 0
Oversize pkts 0 Fragments 0
Jabbers 0 Collisions 0
64 octets pkts 0 65 to 127 octets pkts 0
128 to 255 octets pkts 0 256 to 511 octets pkts 0
512 to 1023 octets pkts 0 1024 to 1518 octets pkts 0