Displaying ospf external link state information – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 689

Brocade TurboIron 24X Series Configuration Guide
655
53-1003053-01
Displaying OSPF information
Displaying OSPF external link state information
To display external link state information, enter the following command at any CLI level.
Syntax: show ip ospf database external-link-state [advertise
The advertise
determine an LSA packet position in the table, enter the show ip ospf external-link-state command
to display the table. Refer to
“Displaying the data in an LSA”
on page 656 for an example.
The extensive option displays the LSAs in decrypted format.
NOTE
You cannot use the extensive option in combination with other display options. The entire database
is displayed.
The link-state-id
The router-id
The sequence-number <num(Hex)> parameter displays the External LSA entries for the specified
hexadecimal LSA sequence number.
The status
This display shows the following information.
TABLE 102
CLI display of OSPF external link state information
This field...
Displays...
Area ID
The OSPF area the router is in.
Aging
The age of the LSA, in seconds.
LS ID
The ID of the link-state advertisement from which the Layer 3 Switch learned this route.
Router
The router IP address.
TurboIron#show ip ospf redistribute route 10.1.0.0 255.255.0.0
10.1.0.0 255.255.0.0 static
TurboIron#show ip ospf database external-link-state
Index Aging LS ID Router Netmask Metric Flag
1 1794 10.1.168.64 10.85.0.3 ffffe000 000003e8 b500 0.0.0.0
2 1794 10.3.215.0 10.85.0.3 ffff0000 000003e8 b500 0.0.0.0
3 1794 10.1.27.250 10.85.0.3 fffffe00 000003e8 b500 0.0.0.0
4 1794 10.1.24.23 10.85.0.3 ffffff00 000003e8 b500 0.0.0.0
5 1794 10.1.21.52 10.85.0.3 ffffff00 000003e8 b500 0.0.0.0
6 1794 10.1.18.81 10.85.0.3 ffffff00 000003e8 b500 0.0.0.0
7 1794 10.1.15.110 10.85.0.3 ffffff00 000003e8 b500 0.0.0.0
8 1794 10.1.12.139 10.85.0.3 ffffff00 000003e8 b500 0.0.0.0
9 1794 10.1.9.168 10.85.0.3 ffffff00 000003e8 b500 0.0.0.0