beautypg.com

Brocade TurboIron 24X Series Configuration Guide User Manual

Page 1087

background image

Brocade TurboIron 24X Series Configuration Guide

1053

53-1003053-01

Syslog messages

Alert

System: No Free Tcam Entry available.
System will be unstable

The limit for the TCAM routing entries has
been reached. You must reboot the device.

Alert

System: Temperature is over shutdown level,
system is going to be reset in
seconds

The chassis temperature has risen above
shutdown level. The system will be shut
down in the amount of time indicated.

Alert

Temperature C degrees, warning
level C degrees, shutdown
level C degrees

Indicates an over temperature condition on
the active module.
The value indicates the
temperature of the module.
The value is the warning
threshold temperature configured for the
module.
The value is the
shutdown temperature configured for the
module.

Critical

Authentication shut down due to
DOS attack

Denial of Service (DoS) attack protection
was enabled for multi-device port
authentication on the specified ,
and the per-second rate of RADIUS
authentication attempts for the port
exceeded the configured limit. The device
considers this to be a DoS attack and
disables the port.

Debug

BGP4: Not enough memory available to run
BGP4

The device could not start the BGP4 routing
protocol because there is not enough
memory available.

Debug

DOT1X: Not enough memory

There is not enough system memory for
802.1X authentication to take place.
Contact Brocade Technical Support.

Error

No of prefixes received from BGP peer
exceeds maximum
prefix-limit...shutdown

The Layer 3 Switch has received more than
the specified maximum number of prefixes
from the neighbor, and the Layer 3 Switch is
therefore shutting down its BGP4 session
with the neighbor.

Information

IPv6: IPv6 protocol disabled on the device
from

IPv6 protocol was disabled on the device
during the specified session.

Information

IPv6: IPv6 protocol enabled on the device
from

IPv6 protocol was enabled on the device
during the specified session.

Information

MAC Filter applied to port by
from (filter
id= )

Indicates a MAC filter was applied to the
specified port by the specified user during
the specified session.
can be console, telnet, ssh,
web, or snmp.
is a list of the MAC filters that
were applied.

TABLE 176

Brocade Syslog messages (Continued)

Message level

Message

Explanation