Enabling pim sm snooping on a vlan, Disabling pim sm snooping on a vlan, Igmp snooping show commands – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 816: Displaying the igmp snooping configuration

782
Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
IGMP snooping show commands
NOTE
The device must be in passive mode before it can be configured for PIM SM snooping.
To disable the feature, enter the following command.
TurboIron(config)#no ip pimsm-snooping
If you also want to disable IP multicast traffic reduction, enter the following command.
TurboIron(config)#no ip multicast
Syntax: [no] ip pimsm-snooping
Enabling PIM SM snooping on a VLAN
You can enable PIM SM snooping for a specific VLAN. For example, the following commands enable
PIM SM snooping on VLAN 20.
TurboIron(config)#vlan 20
TurboIron(config-vlan-20)#multicast pimsm-snooping
Syntax: [no] multicast pimsm-snooping
Disabling PIM SM snooping on a VLAN
When PIM SM snooping is enabled globally, you can still disable it for a specific VLAN. For example,
the following commands disable PIM SM snooping for VLAN 20. This setting overrides the global
setting.
TurboIron(config)#vlan 20
TurboIron(config-vlan-20)#multicast disable-pimsm-snoop
Syntax: [no] multicast disable-pimsm-snoop
IGMP snooping show commands
This section shows how to display information about IGMP snooping, including:
•
“Displaying the IGMP snooping configuration”
•
“Displaying IGMP snooping errors”
•
“Displaying IGMP group information”
•
“Displaying IGMP snooping mcache information”
•
“Displaying software resource usage for VLANs”
•
“Displaying the status of IGMP snooping traffic”
Displaying the IGMP snooping configuration
To display the global IGMP snooping configuration, enter the following command at any level of the
CLI.