Brocade TurboIron 24X Series Configuration Guide - Manual (Page 47)

Brocade TurboIron 24X Series Configuration Guide 13
53-1003053-01
Logging on through the CLI
To display the management interface statistics in brief form, enter the show statistics brief
management command.
Syntax: show statistics brief management <num>
Logging on through the CLI
Once an IP address is assigned to an Brocade device running Layer 2 software or to an interface on
an Brocade device running Layer 3 software, you can access the CLI either through the direct serial
connection to the device or through a local or remote Telnet session.
You can initiate a local Telnet or SNMP connection by attaching a cable to a port and specifying the
assigned management station IP address.
The commands in the CLI are organized into the following levels:
• User EXEC – Lets you display information and perform basic tasks such as pings and
traceroutes.
• Privileged EXEC – Lets you use the same commands as those at the User EXEC level plus
configuration commands that do not require saving the changes to the system-config file.
• CONFIG – Lets you make configuration changes to the device. To save the changes across
reboots, you need to save them to the system-config file. The CONFIG level contains sub-levels
for individual ports, for VLANs, for routing protocols, and other configuration areas.
NOTE
By default, any user who can open a serial or Telnet connection to the Brocade device can access
all these CLI levels. To secure access, you can configure Enable passwords or local user accounts,
or you can configure the device to use a RADIUS or TACACS/TACACS+ server for authentication.
Refer to
Chapter 5, “Securing Access to Management Functions” .
TurboIron#show statistics management 1
Port Link State Dup Speed Trunk Tag Pvid Pri MAC Name
mgmt1 Up None Full100M None No 1 0 00000.0000.0118
InOctets 3210941 OutOctets 1540
InPkts 39939 OutPackets 22
InBroadcastPkts 4355 OutbroadcastPkts 0
InMultiastPkts 35214 OutMulticastPkts 6
InUnicastPkts 370 OutUnicastPkts 16
InBadPkts 0
InFragments 0
InDiscards 0 OutErrors 0
CRC 0 Collisions 0
InErrors 0 LateCollisions 0
InGiantPkts 0
InShortPkts 0
InJabber 0
InFlowCtrlPkts 0 OutFlowCtrlPkts 0
InBitsPerSec 83728 OutBitsPerSec 24
InPktsPerSec 130 OutPktsPerSec 0
InUtilization 0.01% OutUtilization 0.00%