Brocade TurboIron 24X Series Configuration Guide - Manual (Page 163)

Brocade TurboIron 24X Series Configuration Guide 129
53-1003053-01
Displaying SSH connection information
Syntax: show ip ssh [begin | exclude | include ]
This display shows the following information about the active SSH connections.
The show who command also displays information about SSH connections.
Example
Syntax: show who [begin | exclude | include ]
TABLE 28 SSH connection information
This field... Displays...
Connection The SSH connection ID. This can be from 1 – 5.
Version The SSH version number. This should always be 1.5.
Encryption The encryption method used for the connection.
Username The user name for the connection.
TurboIron#show ip ssh
Connection Version Encryption Username
1 SSH-2 3des-cbc Hanuma
2 SSH-2 3des-cbc Mikaila
3 SSH-2 3des-cbc Jenny
4 SSH-2 3des-cbc Mariah
5 SSH-2 3des-cbc Logan
TurboIron#show who
Console connections:
established, monitor enabled, in config mode
2 minutes 17 seconds in idle
Telnet connections (inbound):
1 closed
2 closed
3 closed
4 closed
5 closed
Telnet connection (outbound):
6 closed
SSH connections:
1 established, client ip address 192.168.144.241, user is hanuma
1 minutes 16 seconds in idle
2 established, client ip address 192.168.144.241, user is Mikaila
you are connecting to this session
18 seconds in idle
3 established, client ip address 192.168.144.241, user is Jenny
1 minutes 39 seconds in idle
4 established, client ip address 192.168.144.242, user is Mariah
41 seconds in idle
5 established, client ip address 192.168.144.241, user is Logan
23 seconds in idle