Brocade TurboIron 24X Series Configuration Guide - Manual (Page 393)

Brocade TurboIron 24X Series Configuration Guide 359
53-1003053-01
Configuring single link LACP
Configuration notes
• This feature is supported on 1-GbE and 10-GbE ports.
• This feature is not supported on static trunk ports.
• This feature is not intended for the creation of trunk groups.
• The single link LACP timer is always short (3 seconds) and is not configurable. PDUs are sent
out every three seconds.
• This feature is not supported on ports that have the link-keepalive command (UDLD)
configured.
CLI syntax
To form a single link LACP, the port on both sides of the link must have LACP enabled. You can then
define a single link LACP at the interface level of the device by entering the following command.
TurboIron(config)#interface ethernet 1
TurboIron(config-if-e10000-1)#link-aggregate configure singleton
Link-aggregation active
Syntax: [no] link-aggregate configure singleton
When single link LACP is configured, the show link-aggregate command displays the following
information.
If singleton is configured on the port, the “Key” column displays “singleton”. Refer to “CLI display of
link aggregation information” on page 356 to interpret the information on the displayed output.
Also, when ports are logically brought up or down while singleton is configured on the port, the
following Syslog messages are generated:
• Logical link on interface ethernet is up.
• Logical link on interface ethernet is down.
TurboIron#show link-agg
System ID: 0000.0017.50bb
Long timeout: 120, default: 120
Short timeout: 3, default: 3
Port [Sys P] [Port P] [ Key ] [Act][Tio][Agg][Syn][Col][Dis][Def][Exp][Ope]
5 1 1 20000 No L Agg Syn Col Dis No No Ope
6 1 1 20000 No L Agg Syn Col Dis No No Ope
25 1 1 10000 Yes L Agg Syn Col Dis No No Ope
26 1 1 10000 Yes L Agg Syn Col Dis No No Ope