Network monitoring, Basic management, Viewing system information – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 265: Appendix 13, Appendix

Brocade TurboIron 24X Series Configuration Guide
231
53-1003053-01
Appendix
13
Network Monitoring
In this chapter
•
•
•
•
Configuring a utilization list for an uplink port . . . . . . . . . . . . . . . . . . . . . . 251
This appendix describes the remote monitoring features available on devices.
Basic management
The following sections contain procedures for basic system management tasks.
Viewing system information
You can access software and hardware specifics for a Layer 2 Switch or Layer 3 Switch. For
software specifics, refer to
“Determining the software versions installed and running on a device”
To view the software and hardware details for the system, enter the show version command. The
following shows an example output.
Syntax: show version
TurboIron#show version
SW: Version 07.2.02b071T203 Copyright (c) 1996-2010 Brocade Communications
Systems, Inc.
Compiled on Dec 02 2010 at 08:07:06 labeled as TIR07202b071
(6092645 bytes) from Secondary TIR07202b071
Compressed Boot-Monitor Image size = 373767, Version:04.1.00T205 (grz04100)
HW: Stackable TurboIron-X24
==========================================================================
Serial #: XXXXXXXXXXX
P-ASIC 0: type B820, rev 01 subrev 00
==========================================================================
833 MHz Power PC processor 8541 (version 32/0020) 66 MHz bus
512 KB boot flash memory
31744 KB code flash memory
512 MB DRAM
The system uptime is 5 minutes 34 seconds
The system : started=warm start reloaded=by "reload"