Brocade TurboIron 24X Series Configuration Guide - Manual (Page 1105)

Brocade TurboIron 24X Series Configuration Guide 1071
53-1003053-01
Syslog messages
Notification OSPF virtual nbr state changed,
rid , nbr addr ,
nbr rid <nbr-router-id>, state Indicates that the state of an OSPF virtual
neighbor has changed.
The is the router ID of the
device.
The is the IP address of the
neighbor.
The <nbr-router-id> is the router ID of the
neighbor.
The indicates the state to
which the interface has changed and can
be one of the following:
•
down
•
attempt
•
initializing
•
2-way
•
exchange start
•
exchange
•
loading
•
full
•
unknown
Notification Transit ICMP in interface
exceeds burst packets, stopping for
seconds!! Threshold parameters for ICMP transit
(through) traffic have been configured on
an interface, and the maximum burst size
for ICMP packets on the interface has been
exceeded.
The is the port number.
The first is the maximum burst size
(maximum number of packets allowed).
The second is the number of
seconds during which additional ICMP
packets will be blocked on the interface.
NOTE: This message can occur in response
to an attempted Smurf attack.
Notification Transit TCP in interface exceeds
burst packets, stopping for
seconds! Threshold parameters for TCP transit
(through) traffic have been configured on
an interface, and the maximum burst size
for TCP packets on the interface has been
exceeded.
The is the port number.
The first is the maximum burst size
(maximum number of packets allowed).
The second is the number of
seconds during which additional TCP
packets will be blocked on the interface.
NOTE: This message can occur in response
to an attempted TCP SYN attack.
TABLE 176 Brocade Syslog messages (Continued)
Message level Message Explanation