Brocade TurboIron 24X Series Configuration Guide - Manual (Page 821)

Brocade TurboIron 24X Series Configuration Guide 787
53-1003053-01
IGMP snooping show commands
Displaying the status of IGMP snooping traffic
To display status information for IGMP snooping traffic, enter the following command.
Syntax: show ip multicast traffic
The following table describes the information displayed by the show ip multicast traffic command.
Table 0.8:
This field... Displays...
Q Query
Qry General Query
QryV2 Number of general IGMP V2 queries received or sent.
QryV3 Number of general IGMP V3 queries received or sent.
G-Qry Number of group-specific queries received or sent.
GSQry Number of group source-specific queries received or sent.
Mbr The membership report.
MbrV2 The IGMP V2 membership report.
MbrV3 The IGMP V3 membership report.
IsIN Number of source addresses that were included in the traffic.
IsEX Number of source addresses that were excluded in the traffic.
ToIN Number of times the interface mode changed from EXCLUDE to INCLUDE.
ToEX Number of times the interface mode changed from INCLUDE to EXCLUDE.
ALLO Number of times that additional source addresses were allowed on the interface.
BLK Number of times that sources were removed from an interface.
Pkt-Err Number of packets having errors, such as checksum.
Pimsm-snooping
hello, join, prune Number of PIM sparse hello, join, and prune packets
TurboIron#show ip multicast traffic
IGMP snooping: Total Recv: 22, Xmit: 26
Q: query, Qry: general Q, G-Qry: group Q, GSQry: group-source Q, Mbr: member
Recv QryV2 QryV3 G-Qry GSQry MbrV2 MbrV3 Leave
VL1 0 0 0 0 4 0 0
VL70 18 0 0 0 0 0 0
Recv IsIN IsEX ToIN ToEX ALLOW BLOCK Pkt-Err
VL1 0 4 0 0 0 0 0
VL70 0 0 0 0 0 0 0
Send QryV2 QryV3 G-Qry GSQry MbrV2 MbrV3
VL1 0 0 8 0 0 0
VL70 0 0 0 0 0 18
VL70 pimsm-snooping, Hello: 12, Join/Prune: 9