Brocade TurboIron 24X Series Configuration Guide - Manual (Page 624)

590 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
802.1s Multiple Spanning Tree Protocol
To display details about the MSTP that is configured on the device, enter the following command.
Refer to Table 94 for explanation about the parameters in the output.
Syntax: show mstp [ | configuration | detail] [ | begin | exclude |
include ]
Enter an MSTP ID for .
TurboIron#show mstp conf
MSTP CONFIGURATION
------------------
Name : Reg1
Revision : 1
Version : 3 (MSTP mode)
Status : Started
Instance VLANs
-------- ------------------------------------------------------
0 4093
TurboIron#show mstp detail
MSTP Instance 0 (CIST) - VLANs: 4093
----------------------------------------------------------------------------
Bridge: 8000000000c00000 [Priority 32768, SysId 0, Mac 000000c00000]
FwdDelay 15, HelloTime 2, MaxHops 20, TxHoldCount 6
Port 54 - Role: DESIGNATED - State: FORWARDING
PathCost 20000, Priority 128, OperEdge T, OperPt2PtMac F, Boundary T
Designated - Root 8000000000c00000, RegionalRoot 8000000000c00000,
Bridge 8000000000c00000, ExtCost 0, IntCost 0
ActiveTimers - helloWhen 1
MachineState - PRX-DISCARD, PTX-IDLE, PPM-SENDING_RSTP, PIM-CURRENT
PRT-ACTIVE_PORT, PST-FORWARDING, TCM-INACTIVE
BPDUs - Rcvd MST 0, RST 0, Config 0, TCN 0
Sent MST 6, RST 0, Config 0, TCN 0