Brocade TurboIron 24X Series Configuration Guide - Manual (Page 54)

20 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Logging on through Brocade Network Advisor
After the alias is configured, entering shoro at either the Privileged EXEC or CONFIG levels of the CLI
executes the show ip route command.
To create an alias called wrsbc for copy running-config tftp 10.10.10.10 test.cfg, enter the following
command.
TurboIron(config)#alias wrsbc = copy running-config tftp 10.10.10.10 test.cfg
To remove the wrsbc alias from the configuration, enter one of the following commands.
TurboIron(config)#no alias wrsbc
or
TurboIron(config)#unalias wrsbc
Syntax: unalias <alias-name>
The specified must be the name of an alias already configured on the device.
To display the aliases currently configured on the device, enter the following command at either the
Privileged EXEC or CONFIG levels of the CLI.
TurboIron#alias
wrsbc copy running-config tftp 10.10.10.10 test.cfg
shoro show ip route
Syntax: alias
Configuration notes
The following configuration notes apply to this feature:
• You cannot include additional parameters with the alias at the command prompt. For example,
after you create the shoro alias, shoro bgp would not be a valid command.
• If configured on the device, authentication, authorization, and accounting is performed on the
actual command, not on the alias for the command.
• To save an alias definition to the startup-config file, use the write memory command.
Logging on through Brocade Network Advisor
Refer to the Brocade Network Advisor manuals for information about using Brocade Network
Advisor.