Brocade TurboIron 24X Series Configuration Guide - Manual (Page 304)

270 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Egress buffer thresholds for QoS priorities
TurboIron(config)#no enable egress-buffer-default
This command disables the default values for all traffic classes on all ports. Once disabled, you
can configure new threshold values as instructed in
“Setting the egress buffer threshold for all QoS
priorities on a port or group of ports” on page 270 and “Setting the egress buffer threshold for a
specific QoS priority on a port or group of ports” on page 270.
Syntax: [no] enable egress-buffer-default
To re-enable the default settings for egress buffer thresholds once they have been disabled, enter
the following command.
TurboIron(config)#enable egress-buffer-default
The device reverts to using the default values for all traffic classes on all ports, as described in
“Default settings for egress buffer thresholds” on page 269.
Syntax: enable egress-buffer-default
Setting the egress buffer threshold for all QoS
priorities on a port or group of ports
NOTE
Be sure to disable the default settings before performing the tasks in this section. Refer to
“Disabling and re-enabling the default settings for egress buffer thresholds” .
To set the egress buffer threshold for all QoS prioritiies (0 – 7) on a port, enter commands such as
the following.
TurboIron(config)#int e 3
TurboIron(conf-if-e10000-3)#egress-buffer-threshold min
To set the egress buffer threshold for all QoS priorities on multiple ports, enter commands such as
the following.
TurboIron(config)#int e 4 to 5
TurboIron(config-mif-e10000-4-5)#egress-buffer-threshold min
These commands set the egress buffer threshold for all QoS priorities on ports e 3, and ports e 4
and 5, to the minimum (min) threshold.
Syntax: [no] egress-buffer-threshold min|level-1|level-2|level-3|level-4|level-5|level-6|max
Use the no form of the command to revert back to the default values for all QoS priorities on the
port. For the default values, refer to
“Default settings for egress buffer thresholds” on page 269.
Setting the egress buffer threshold for a specific
QoS priority on a port or group of ports
NOTE
Be sure to disable the default settings before performing the tasks in this section. Refer to
“Disabling and re-enabling the default settings for egress buffer thresholds” .
To set the egress buffer threshold for a specific QoS priority on a port, enter commands such as the
following.