Brocade TurboIron 24X Series Configuration Guide User Manual

Page 877

Brocade TurboIron 24X Series Configuration Guide

843

53-1003053-01

Multicast Source Discovery Protocol (MSDP)

TurboIron(config-router-bsr)#neighbor 10.32.32.2 remote-as 222

TurboIron(config-router-bsr)#neighbor 10.32.32.2 next-hop-self

TurboIron(config-router-bsr)#neighbor 10.34.34.4 remote-as 444

TurboIron(config-router-bsr)#neighbor 10.34.34.4 next-hop-self

TurboIron(config-router-bsr)#neighbor 10.31.31.1 remote-as 111

TurboIron(config-router-bsr)#neighbor 10.31.31.1 next-hop-self

TurboIron(config-router-bsr)#redistribute connected

TurboIron(config-router-bsr)#write memory

Configuration for Device D

The following set of commands configure the MSDP peers of Device D (10.1.4.1) that are inside
and outside MSDP mesh group 1234. Device D peers inside the mesh group 1234 are 10.1.1.1,
10.1.2.1, and 10.1.3.1. Device 10.48.48.8 and 10.134.134.13 are also peers of Device D, but are
outside mesh group 1234. Multicast is enabled on Device D interfaces. PIM and BGP are also
enabled.

TurboIron(config)#router pim

TurboIron(config)#router msdp

TurboIron(config-msdp-router)#msdp-peer 10.1.3.1 connect-source loopback 1

TurboIron(config-msdp-router)#msdp-peer 10.1.1.1 connect-source loopback 1

TurboIron(config-msdp-router)#msdp-peer 10.1.2.1 connect-source loopback 1

TurboIron(config-msdp-router)#msdp-peer 10.48.48.8

TurboIron(config-msdp-router)#msdp-peer 10.134.134.13

TurboIron(config-msdp-router)#mesh-group 1234 10.1.1.1

TurboIron(config-msdp-router)#mesh-group 1234 10.1.3.1

TurboIron(config-msdp-router)#mesh-group 1234 10.1.2.1

TurboIron(config-msdp-router)#exit

TurboIron(config)#interface loopback 1

TurboIron(config-lbif-)#ip address 10.1.4.1 255.255.255.0

TurboIron(config-lbif-)#ip pim-sparse

TurboIron(config-lbif-)#exit

TurboIron(config)#interface ethernet 1/1

TurboIron(config-if-)#ip address 10.24.24.4 255.255.255.0