Setting radius parameters, Configuration example and command syntax, Setting the radius key – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 142
108
Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Configuring RADIUS security
Configuration example and command syntax
To map a RADIUS server to a port, enter commands such as the following.
TurboIron(config)#int e 3
TurboIron(config-if-e10000-3)#dot1x port-control auto
TurboIron(config-if-e10000-3)#use-radius-server 10.10.10.103
TurboIron(config-if-e10000-3)#use-radius-server 10.10.10.110
With the above configuration, port e 3 would send a RADIUS request to 10.10.10.103 first, since it
is the first server mapped to the port. If it fails, it will go to 10.10.10.110.
Syntax: use-radius-server
The host
Setting RADIUS parameters
You can set the following parameters in a RADIUS configuration:
•
RADIUS key – This parameter specifies the value that the device sends to the RADIUS server
when trying to authenticate user access.
•
Retransmit interval – This parameter specifies how many times the device will resend an
authentication request when the RADIUS server does not respond. The retransmit value can be
from 1 – 5 times. The default is 3 times.
•
Timeout – This parameter specifies how many seconds the device waits for a response from a
RADIUS server before either retrying the authentication request, or determining that the
RADIUS servers are unavailable and moving on to the next authentication method in the
authentication-method list. The timeout can be from 1 – 15 seconds. The default is 3 seconds.
Setting the RADIUS key
The key parameter in the radius-server command is used to encrypt RADIUS packets before they
are sent over the network. The value for the key parameter on the device should match the one
configured on the RADIUS server. The key can be from 1 – 32 characters in length and cannot
include any space characters.
To specify a RADIUS server key, enter a command such as the following.
TurboIron(config)#radius-server key mirabeau
Syntax: radius-server key [0 | 1]
When you display the configuration of the device, the RADIUS key is encrypted.
Example
TurboIron(config)#radius-server key 1 abc
TurboIron(config)#write terminal
...
radius-server host 10.2.3.5
radius key 1 $!2d
NOTE
Encryption of the RADIUS keys is done by default. The 0 parameter disables encryption. The 1
parameter is not required; it is provided for backwards compatibility.