Brocade TurboIron 24X Series Configuration Guide - Manual (Page 283)

Brocade TurboIron 24X Series Configuration Guide 249
53-1003053-01
sFlow
Command syntax
This section shows how to enable sFlow forwarding.
Globally enabling sFlow forwarding
To enable sFlow forwarding, you must first enable it on a global basis, then on individual interfaces
or trunk ports, or both.
To globally enable sFlow forwarding, enter the following command.
TurboIron(config)#sflow enable
You can now enable sFlow forwarding on individual ports as described in the next two sections.
Syntax: [no] sflow enable
Enabling sFlow forwarding on individual interfaces
To enable sFlow forwardingenter commands such as the following.
TurboIron(config)#sflow enable
TurboIron(config)#interface ethernet 1 to 8
TurboIron(config-mif-1-8)#sflow-forwarding
These commands globally enable sFlow, then enable sFlow forwarding on Ethernet ports1 – 8. You
must use both the sflow enable and sflow-forwarding commands to enable the feature.
Syntax: [no] sflow enable
Syntax: [no] sflow-forwarding
Displaying sFlow information
To display sFlow configuration information and statistics, enter the following command at any level
of the CLI.
TurboIron#show sflow
sFlow services are enabled.
sFlow agent IP address: 10.123.123.1
4 collector destinations configured:
Collector IP 192.168.4.204, UDP 6343
Collector IP 192.168.4.200, UDP 6333
Collector IP 192.168.4.202, UDP 6355
Collector IP 192.168.4.203, UDP 6565
Polling interval is 0 seconds.
Configured default sampling rate: 1 per 512 packets
Actual default sampling rate: 1 per 512 packets
10552 UDP packets exported
24127 sFlow samples collected.
sFlow ports: ethe 2 to 12 ethe 15 ethe 25 to 26 ethe 1 ethe 10 to
20 ethe 1 ethe 4
...continued on next page...