Lldp tlvs advertised by the device, General system information – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 234

200
Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Configuring LLDP
To set the re-initialization delay timer, enter a command such as the following at the Global CONFIG
level of the CLI.
TurboIron(config)#lldp reinit-delay 5
The above command causes the device to wait five seconds after LLDP is disabled, before
attempting to honor a request to re-enable it.
Syntax: [no] lldp reinit-delay
where
LLDP TLVs advertised by the device
When LLDP is enabled on a global basis, the device will automatically advertise the following
information, except for the features noted:
General system information:
•
Management address
•
Port description
•
System capabilities
•
System description (not automatically advertised)
•
System name
802.1 capabilities:
•
VLAN name (not automatically advertised)
•
Untagged VLAN ID
802.3 capabilities:
•
Link aggregation information
•
MAC/PHY configuration and status
•
Maximum frame size
•
Power-via-MDI information (not automatically advertised)
The above TLVs are described in detail in the following sections.
NOTE
The system description, VLAN name, and power-via-MDI information TLVs are not automatically
enabled. The following sections show how to enable these advertisements.
General system information
Except for the system description, the device will advertise the following system information when
LLDP is enabled on a global basis:
•
Management address
•
Port description
•
System capabilities
•
System description (not automatically advertised)
•
System name