Brocade TurboIron 24X Series Configuration Guide - Manual (Page 110)

76 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Setting passwords
• All interface configuration levels
• Read Only level gives access to:
• The User EXEC and Privileged EXEC levels
You can grant additional access to a privilege level on an individual command basis. To grant the
additional access, you specify the privilege level you are enhancing, the CLI level that contains the
command, and the individual command.
NOTE
This feature applies only to management privilege levels on the CLI.
Enhance the Port Configuration privilege level so users also can enter IP commands at the global
CONFIG level.
TurboIron(config)#privilege configure level 4 ip
In this command, configure specifies that the enhanced access is for a command at the global
CONFIG level of the CLI. The level 4 parameter indicates that the enhanced access is for
management privilege level 4 (Port Configuration). All users with Port Configuration privileges will
have the enhanced access. The ip parameter indicates that the enhanced access is for the IP
commands. Users who log in with valid Port Configuration level user names and passwords can
enter commands that begin with “ip” at the global CONFIG level.
Syntax: [no] privilege level
The parameter specifies the CLI level and can be one of the following values:
• exec – EXEC level; for example, TurboIron> or TurboIron#
• configure – CONFIG level; for example, TurboIron(config)#
• interface – Interface level; for example, TurboIron(config-if-6)#
• loopback-interface – loopback interface level
• virtual-interface – Virtual-interface level; for example, TurboIron(config-vif-6)#
• dot1x – 802.1X configuration level
• ipv6-access-list – IPv6 access list configuration level
• rip-router – RIP router level; for example, TurboIron(config-rip-router)#
• ospf-router – OSPF router level; for example, TurboIron(config-ospf-router)#
• pim-router – PIM router level; for example, TurboIron(config-pim-router)#
• bgp-router – BGP4 router level; for example, TurboIron(config-bgp-router)#
• vrrp-router – VRRP configuration level
• trunk – trunk configuration level
• port-vlan – Port-based VLAN level; for example, TurboIron(config-vlan)#
• protocol-vlan – Protocol-based VLAN level
The indicates the number of the management privilege level you are augmenting.
You can specify one of the following:
• 0 – Super User level (full read-write access)
• 4 – Port Configuration level
• 5 – Read Only level