Brocade TurboIron 24X Series Configuration Guide - Manual (Page 822)

788 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
PIM SM snooping show commands
PIM SM snooping show commands
This section shows how to display information about PIM SM snooping, including:
• “Displaying PIM SM snooping information”
• “Displaying PIM SM snooping information on a Layer 2 switch”
• “Displaying PIM SM snooping information for a specific group or source group pair”
Displaying PIM SM snooping information
To display PIM SM snooping information, enter the following command.
This output shows the number of PIM join outgoing interfaces (OIF) out of the total OIF. The
join/prune messages are source-specific. In this case, If the mcache is in (* G), the display function
will also print the traffic source information.
Syntax: show ip multicast pimsm-snooping []
Use the parameter to display PIM SM snooping information for a specific VLAN.
Displaying PIM SM snooping information on a Layer 2 switch
You can display PIM SM snooping information for all groups by entering the following command at
any level of the CLI on a Layer 2 Switch.
TurboIron#show ip multicast pimsm-snooping
vlan 1, has 2 caches.
1 (* 230.1.1.1) has 1 pim join ports out of 1 OIF
1 (age=60)
1 has 1 src: 10.20.20.66(60)
2 (* 230.2.2.2) has 1 pim join ports out of 1 OIF
1 (age=60)
1 has 1 src: 10.20.20.66(60)
TurboIron#show ip multicast pimsm-snooping vlan 100
VLAN ID 100, total 3 entries
PIMSM Neighbor list:
10.100.100.12 : 3 expire 120 s
10.100.100.10 : 3 expire 170 s
10.100.100.7 : 3 expire 160 s
1 Group: 224.0.1.22, fid 08ac, NO cam
Forwarding Port: 3
PIMv2 Group Port: 3
(Source, Port) list: 1 entries
2 Group: 239.255.162.2, fid 08aa, cam 8
Forwarding Port: 1 2
PIMv2 Group Port: 1 2
(Source, Port) list: 3 entries
3 Group: 239.255.163.2, fid 08a9, cam 10
Forwarding Port: 1 2
PIMv2 Group Port: 1 2
(Source, Port) list: 3 entries
VLAN ID 4008, total 0 entries
PIMSM Neighbor list: