Brocade TurboIron 24X Series Configuration Guide - Manual (Page 1094)

1060 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Syslog messages
Informational vlan Bridge is RootBridge
(MsgAgeExpiry)
The message age expired on the Root port
so 802.1W changed the current bridge to
be the root bridge of the topology.
Informational vlan interface Bridge
TC Event (DOT1wTransition)
802.1W recognized a topology change
event in the bridge. The topology change
event is the forwarding action that started
on a non-edge Designated port or Root port.
Informational vlan interface STP
state -> (DOT1wTransition)
802.1W changed the state of a port to a
new state: forwarding, learning, blocking. If
the port changes to blocking, the bridge
port is in discarding state.
Informational vlan New RootBridge
RootPort
(BpduRcvd)
802.1W selected a new root bridge as a
result of the BPDUs received on a bridge
port.
Informational vlan New RootPort
(RootSelection)
802.1W changed the port role to Root port,
using the root selection computation.
Notification ACL exceed max DMA L4 cam resource,
using flow based ACL instead The port does not have enough Layer 4 CAM
entries for the ACL.
To correct this condition, allocate more
Layer 4 CAM entries. To allocate more Layer
4 CAM entries, enter the following
command at the CLI configuration level for
the interface:
ip access-group max-l4-cam
Notification ACL insufficient L4 cam resource, using flow
based ACL instead The port does not have a large enough CAM
partition for the ACLs
Notification ACL insufficient L4 session resource, using
flow based ACL instead The device does not have enough Layer 4
session entries.
To correct this condition, allocate more
memory for sessions. To allocate more
memory, enter the following command at
the global CONFIG level of the CLI interface:
system-max session-limit
Notification ACL port fragment packet inspect rate
exceeded on port The fragment rate allowed on an individual
interface has been exceeded.
The indicates the maximum rate
allowed.
The indicates the port.
This message can occur if fragment
thottling is enabled.
Notification ACL system fragment packet inspect rate
exceeded The fragment rate allowed on the device
has been exceeded.
The indicates the maximum rate
allowed.
This message can occur if fragment
thottling is enabled.
Notification Authentication Disabled on The multi-device port authentication feature
was disabled on the on the specified
.
TABLE 176 Brocade Syslog messages (Continued)
Message level Message Explanation