beautypg.com

Displaying ospf trap status – Brocade TurboIron 24X Series Configuration Guide User Manual

Page 692

background image

658

Brocade TurboIron 24X Series Configuration Guide

53-1003053-01

Displaying OSPF information

Syntax: show ip ospf border-routers []

The parameter displays the ABR and ASBR entries for the specified IP address.

Displaying OSPF trap status

All traps are enabled by default when you enable OSPF. To disable or re-enable an OSPF trap, refer
to

“Modify OSPF traps generated”

on page 642.

To display the state of each OSPF trap, enter the following command at any CLI level.

Syntax: show ip ospf trap

TurboIron#show ip ospf trap

Interface State Change Trap: Enabled

Virtual Interface State Change Trap: Enabled

Neighbor State Change Trap: Enabled

Virtual Neighbor State Change Trap: Enabled

Interface Configuration Error Trap: Enabled

Virtual Interface Configuration Error Trap: Enabled

Interface Authentication Failure Trap: Enabled

Virtual Interface Authentication Failure Trap: Enabled

Interface Receive Bad Packet Trap: Enabled

Virtual Interface Receive Bad Packet Trap: Enabled

Interface Retransmit Packet Trap: Enabled

Virtual Interface Retransmit Packet Trap: Enabled

Originate LSA Trap: Enabled

Originate MaxAge LSA Trap: Enabled

Link State Database Overflow Trap: Enabled

Link State Database Approaching Overflow Trap: Enabled