Brocade TurboIron 24X Series Configuration Guide User Manual
Page 1107
Brocade TurboIron 24X Series Configuration Guide
1073
53-1003053-01
Syslog messages
Warning
list
(Ethernet
<dst-ip-addr> (<dst-tcp/udp-port>),
1 event(s)
Indicates that an Access Control List (ACL)
denied (dropped) packets.
The
Numbers 1 – 99 indicate standard ACLs.
Numbers 100 – 199 indicate extended
ACLs.
The
the denied packets.
The <src-ip-addr> is the source IP address
of the denied packets.
The <src-tcp/udp-port> is the source TCP or
UDP port, if applicable, of the denied
packets.
The
on which the packet was denied.
The
address of the denied packets.
The <dst-ip-addr> indicates the destination
IP address of the denied packets.
The <dst-tcp/udp-port> indicates the
destination TCP or UDP port number, if
applicable, of the denied packets.
Warning
Locked address violation at interface
e
Indicates that a port on which you have
configured a lock-address filter received a
packet that was dropped because the
packet source MAC address did not match
an address learned by the port before the
lock took effect.
The e
The
that was denied by the address lock.
Assuming that you configured the port to
learn only the addresses that have valid
access to the port, this message indicates a
security violation.
Warning
mac filter group denied packets on port
Indicates that a Layer 2 MAC filter group
configured on a port has denied packets.
The
packets were denied.
The
of the denied packets.
The
matching the values above were dropped
during the five-minute interval represented
by the log entry.
Warning
multicast no software resource:
resource-name, rate limited number
IGMP or MLD snooping has run out of
software resources. This message is
rate-limited to appear a maximum of once
every 10 minutes. The rate-limited number
shows the number of non-printed warnings.
TABLE 176
Brocade Syslog messages (Continued)
Message level
Message
Explanation