Brocade TurboIron 24X Series Configuration Guide - Manual (Page 679)

Brocade TurboIron 24X Series Configuration Guide 645
53-1003053-01
Clearing OSPF information
TurboIron#clear ip ospf neighbor
Syntax: clear ip ospf neighbor [ip | id ]
This command clears all OSPF neighbors and the OSPF routes exchanged with the neighbors in the
OSPF link state database. After this information is cleared, adjacencies with all neighbors are
re-established, and routes with these neighbors exchanged again.
To clear information on the device about OSPF neighbor 10.10.10.1, enter the following command.
TurboIron#clear ip ospf neighbor ip 10.10.10.1
This command clears the OSPF neighbor and the OSPF routes exchanged with neighbor 10.10.10.1
in the OSPF link state database in the device. After this information is cleared, the adjacency with
the neighbor is re-established, and routes are exchanged again.
The neighbor router can be specified either by its IP address or its router ID. To specify the neighbor
router using its IP address, use the ip parameter. To specify the neighbor router using its
router ID, use the id parameter.
Clearing OSPF topology information
To clear OSPF topology information on the device, enter the following command.
TurboIron#clear ip ospf topology
Syntax: clear ip ospf topology
This command clears all OSPF routes from the OSPF routing table, including intra-area, (which
includes ABR and ASBR intra-area routes), inter-area, external type 1, external type 2, OSPF default,
and OSPF summary routes.
After you enter this command, the OSPF routing table is rebuilt, and valid routes are recomputed
from the OSPF link state database. When the OSPF routing table is cleared, OSPF routes in the
global routing table are also recalculated. If redistribution is enabled, the routes are imported
again.
Clearing redistributed routes from the OSPF routing table
To clear all routes in the OSPF routing table that were redistributed from other protocols, enter the
following command.
TurboIron#clear ospf redistribution
Syntax: clear ospf redistribution
This command clears all routes in the OSPF routing table that are redistributed from other
protocols, including direct connected, static, RIP, and BGP. To import redistributed routes from
other protocols, use the redistribution command at the OSPF configuration level.
Clearing information for OSPF areas
To clear information on the device about all OSPF areas, enter the following command.
TurboIron#clear ip ospf