Displaying multicast neighbor information – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 859

Brocade TurboIron 24X Series Configuration Guide
825
53-1003053-01
PIM Sparse
Syntax: show ip pim rp-set
This display shows the following information.
Displaying multicast neighbor information
To display information about the Layer 3 Switch PIM neighbors, enter the following command at any
CLI level.
Syntax: show ip pim nbr
This display shows the following information.
TABLE 124
Output of show ip pim rp-set command
This field...
Displays...
Number of group prefixes
The number f PIM Sparse group prefixes for which the RP is responsible.
Group prefix
Indicates the multicast groups for which the RP listed by the previous field is a
candidate RP.
RPs expected/received
Indicates how many RPs were expected and received in the latest Bootstrap
message.
RP
Indicates the RP number. If there are multiple RPs in the PIM Sparse domain, a
line of information for each of them is listed, and they are numbered in ascending
numerical order.
priority
The RP priority of the candidate RP. During the election process, the candidate RP
with the highest priority is elected as the RP.
age
The age (in seconds) of this RP-set.
NOTE: If this Layer 3 Switch is not a BSR, this field contains zero. Only the BSR
ages the RP-set.
TABLE 125
Output of show ip pim nbr command
This field...
Displays...
Port
The interface through which the Layer 3 Switch is connected to the neighbor.
Neighbor
The IP interface of the PIM neighbor interface.
TurboIron#show ip pim rp-set
Group address Static-RP-address Override
---------------------------------------------------
Access-List 44 10.99.99.5 On
Number of group prefixes Learnt from BSR: 1
Group prefix = 239.255.162.0/24 #RPs expected: 1
#RPs received: 1
RP 1: 10.43.43.1 priority=0 age=0
TurboIron#show ip pim nbr
Port Neighbor Holdtime Age UpTime
sec sec sec
e8 10.95.8.10 180 60 900
Port Neighbor Holdtime Age UpTime
sec sec sec
v1 10.95.6.2 180 60 900