beautypg.com

Brocade TurboIron 24X Series Configuration Guide User Manual

Page 924

background image

890

Brocade TurboIron 24X Series Configuration Guide

53-1003053-01

Displaying VRRP and VRRPE information

Syntax: show ip vrrp vrid [ethernet | ve ]

The parameter specifies the VRID.

The ethernet | ve specifies an interface on which the VRID is configured. If you
specify an interface, VRID information is displayed for that interface only. Otherwise, information is
displayed for all the interfaces on which the specified VRID is configured.

This display shows the following information.

TABLE 138

Output from the show ip vrrp vrid command

This field...

Displays...

VRID

The specified VRID.

Interface

The interface on which VRRP is configured.

State

This Layer 3 Switch VRRP state for the VRID. The state can be one of the
following:

Init – The VRID is not enabled (activated). If the state remains Init after
you activate the VRID, make sure that the VRID is also configured on the
other routers and that the routers can communicate with each other.

NOTE: If the state is Init and the mode is incomplete, make sure you have

specified the IP address for the VRID:

Backup – This Layer 3 Switch is a Backup for the VRID.

Master – This Layer 3 Switch is the Master for the VRID.

priority

The configured VRRP priority of this Layer 3 Switch for the VRID.

current priority

The current VRRP priority of this Layer 3 Switch for the VRID.

track-priority

The new VRRP priority that the router receives for this VRID if the interface goes
down

hello-interval

How often the Master router sends Hello messages to the Backups.

dead-interval

The amount of time a Backup waits for a Hello message from the Master before
determining that the Master is dead.

current dead-interval

The current Dead interval. The software automatically adds one-half second to
the Dead interval value you enter.

preempt-mode

Whether the backup preempt mode is enabled. If the backup preempt mode is
enabled, this field contains “true”. If the mode is disabled, this field contains
“false”.

advertise backup

Whether Backup routers send Hello messages to the Master.

TurboIron#show ip vrrp vrid 1

VRID 1

Interface ethernet 11

state initialize

administrative-status disabled

mode non-owner(backup)incomplete

priority 12

current priority 12

track-priority 22

hello-interval 1 sec

dead-interval 0 sec

current dead-interval 3.900 sec

preempt-mode true

advertise backup: disabled