Brocade TurboIron 24X Series Configuration Guide - Manual (Page 134)

100 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Configuring RADIUS security
The following table describes the TACACS/TACACS+ information displayed by the show aaa
command.
Configuring RADIUS security
You can use a Remote Authentication Dial In User Service (RADIUS) server to secure the following
types of access to the Layer 2 Switch or Layer 3 Switch:
• Telnet access
• SSH access
• Access to the Privileged EXEC level and CONFIG levels of the CLI
NOTE
Devices do not support RADIUS security for SNMP (Brocade Network Advisor) access.
RADIUS authentication, authorization, and accounting
When RADIUS authentication is implemented, the device consults a RADIUS server to verify user
names and passwords. You can optionally configure RADIUS authorization, in which the device
consults a list of commands supplied by the RADIUS server to determine whether a user can
execute a command he or she has entered, as well as accounting, which causes the device to log
information on a RADIUS accounting server when specified events occur on the device.
RADIUS authentication
When RADIUS authentication takes place, the following events occur.
TABLE 22 Output of the show aaa command for TACACS/TACACS+
Field Description
Tacacs+ key The setting configured with the tacacs-server key command. At the Super User privilege level,
the actual text of the key is displayed. At the other privilege levels, a string of periods (....) is
displayed instead of the text.
Tacacs+ retries The setting configured with the tacacs-server retransmit command.
Tacacs+ timeout The setting configured with the tacacs-server timeout command.
Tacacs+
dead-time The setting configured with the tacacs-server dead-time command.
Tacacs+ Server For each TACACS/TACACS+ server, the IP address, port, and the following statistics are
displayed:
•
opens - Number of times the port was opened for communication with the server
•
closes - Number of times the port was closed normally
•
timeouts - Number of times port was closed due to a timeout
•
errors - Number of times an error occurred while opening the port
•
packets in - Number of packets received from the server
•
packets out - Number of packets sent to the server
connection The current connection status. This can be “no connection” or “connection active”.