Clearing acl and rate limit counters, Viewing traffic policies – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 973

Brocade TurboIron 24X Series Configuration Guide
939
53-1003053-01
Viewing traffic policies
Syntax: show statistics traffic-policy [
explains the output of the show access-list accounting and show statistics traffic-policy
commands.
Clearing ACL and rate limit counters
The device keeps a running tally of the number of packets and the number of bytes per packet that
are filtered by ACL statements and rate limiting traffic policies. You can clear these accumulated
counters, essentially resetting them to zero. To do so, use either the clear access-list account
traffic-policy or the clear statistics traffic-policy command.
To clear the counters for ACL counting and rate limit counting, enter commands such as the
following.
TurboIron(config)#clear access-list accounting traffic-policy CountOne
TurboIron(config)#clear statistics traffic-policy CountTwo
Syntax: clear access-list accounting traffic-policy
or
Syntax: clear statistics traffic-policy
where
policy counters.
Viewing traffic policies
To view traffic policies that are currently defined on the device, enter the show traffic-policy
command. An example display output is shown below.
defines the output.
TABLE 144
ACL and rate limit counting statistics
This line...
Displays...
Traffic Policy
The name of the traffic policy.
General Counters
Port Region #
The port region to which the active traffic policy applies.
Byte Count
The number of bytes that were filtered (matched ACL clauses).
Packet Count
The number of packets that were filtered (matched ACL clauses).
Rate Limiting Counters
Port Region#
The port region to which the active traffic policy applies.
Green Conformance
The number of bytes that did not exceed the CIR packet rate.
Yellow Conformance
The number of bytes that exceeded the CIR packet rate.
Red Conformance
The number of bytes that exceeded the PIR packet rate.