Brocade TurboIron 24X Series Configuration Guide - Manual (Page 266)

232 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Basic management
Viewing configuration information
You can view a variety of configuration details and statistics with the show option. The show option
provides a convenient way to check configuration changes before saving them to flash.
The show options available will vary for Layer 2 Switches and Layer 3 Switches and by configuration
level.
To determine the available show commands for the system or a specific level of the CLI, enter the
following command.
TurboIron#show ?
Syntax: show
You also can enter “show” at the command prompt, then press the TAB key.
Viewing port statistics
Port statistics are polled by default every 10 seconds.
You can view statistics for ports by entering the following show commands:
• show interfaces
• show configuration
• show statistics
To display the statistics, enter a command such as the following.
Syntax: show statistics [ethernet ]
The parameter is a valid port number.
Table 47 lists the statistics displayed in the output of the show statistics command.
TurboIron#show statistics ethernet 3
Port Link State Dupl Speed Trunk Tag Priori MAC Name
3 Up Forward Half 100M None No level0 0000.0000.0102
Port 3 Counters:
InOctets 3200 OutOctets 256
InPkts 50 OutPkts 4
InBroadcastPkts 0 OutBroadcastPkts 3
InMulticastPkts 48 OutMulticastPkts 0
InUnicastPkts 2 OutUnicastPkts 1
InBadPkts 0
InFragments 0
InDiscards 0 OutErrors 0
CRC 0 Collisions 0
InErrors 0 LateCollisions 0
InGiantPkts 0
InShortPkts 0
InJabber 0
InFlowCtrlPkts 0 OutFlowCtrlPkts 0
InBitsPerSec 264 OutBitsPerSec 16
InPktsPerSec 0 OutPktsPerSec 0
InUtilization 0.00% OutUtilization 0.00%