Displaying neighbors, Displaying cdp entries – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 217

Brocade TurboIron 24X Series Configuration Guide
183
53-1003053-01
Reading CDP packets
•
CDP entries for all Cisco neighbors or a specific neighbor
•
CDP packet statistics
Displaying neighbors
To display the Cisco neighbors the Brocade device has learned from CDP packets, enter the
following command.
To display detailed information for the neighbors, enter the following command.
To display information about a neighbor attached to a specific port, enter a command such as the
following.
Syntax: show fdp neighbors [detail | ethernet
Displaying CDP entries
To display CDP entries for all neighbors, enter the following command.
TurboIron#show fdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater
(*) indicates a Cisco device
Device ID Local Int Holdtm Capability Platform Port ID
-------------- ------------ ------ ---------- ----------- -------------
(*)Router Eth 1 124 R cisco RSP4
FastEthernet0
TurboIron#show fdp neighbors detail
Device ID: Router
Entry address(es):
IP address: 10.95.6.143
Platform: cisco RSP4, Capabilities: Router
Interface: Eth 1, Port ID (outgoing port): FastEthernet0
Holdtime : 150 seconds
Version :
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-JSV-M), Version 12.0(5)T1, RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Thu 19-Aug-99 04:12 by cmong
TurboIron#show fdp neighbors ethernet 1
Device ID: Router
Entry address(es):
IP address: 10.95.6.143
Platform: cisco RSP4, Capabilities: Router
Interface: Eth 1, Port ID (outgoing port): FastEthernet0
Holdtime : 127 seconds
Version :
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-JSV-M), Version 12.0(5)T1, RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Thu 19-Aug-99 04:12 by cmong