Brocade TurboIron 24X Series Configuration Guide User Manual
Page 1096

1062
Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Syslog messages
Notification
Local ICMP exceeds
packets, stopping for
The number of ICMP packets exceeds the
burst command. The device may be the
victim of a Denial of Service (DoS) attack.
All ICMP packets will be dropped for the
number of seconds specified by the
expires, the packet counter is reset and
measurement is restarted.
Notification
Local TCP exceeds
packets, stopping for
The number of TCP SYN packets exceeds
the
burst command. The Brocade device may
be the victim of a TCP SYN DoS attack.
All TCP SYN packets will be dropped for the
number of seconds specified by the
expires, the packet counter is reset and
measurement is restarted.
Notification
Local TCP exceeds
stopping for
Threshold parameters for local TCP traffic
on the device have been configured, and
the maximum burst size for TCP packets
has been exceeded.
The first
(maximum number of packets allowed).
The second
seconds during which additional TCP
packets will be blocked on the device.
NOTE: This message can occur in response
to an attempted TCP SYN attack.
Notification
MAC Authentication RADIUS timeout for
The RADIUS session has timed out for the
MAC address for this port.
Notification
MAC Authentication succeeded for
RADIUS authentication was successful for
the specified
specified
Notification
OSPF interface state changed,
rid
state
Indicates that the state of an OSPF
interface has changed.
The
device.
The
The
which the interface has changed and can
be one of the following:
•
down
•
loopback
•
waiting
•
point-to-point
•
designated router
•
backup designated router
•
other designated router
•
unknown
TABLE 176
Brocade Syslog messages (Continued)
Message level
Message
Explanation