Brocade TurboIron 24X Series Configuration Guide - Manual (Page 780)

746 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Displaying BGP4 information
Displaying the best routes that were nonetheless not installed in the IP route table
To display the BGP4 routes received from a specific neighbor that are the “best” routes to their
destinations but are not installed in the Layer 3 Switch IP route table, enter a command such as the
following at any level of the CLI.
TurboIron#show ip bgp neighbor 10.192.168.4 routes not-installed-best
Each of the displayed routes is a valid path to its destination, but the Layer 3 Switch received
another path from a different source (such as OSPF, RIP, or a static route) that has a lower
administrative distance. The Layer 3 Switch always selects the path with the lowest administrative
distance to install in the IP route table.
Syntax: show ip bgp neighbor routes not-installed-best
For information about the fields in this display, refer to Table 110 on page 751. The fields in this
display also appear in the show ip bgp display.
Displaying the routes whose destinations are unreachable
To display BGP4 routes whose destinations are unreachable using any of the BGP4 paths in the
BGP4 route table, enter a command such as the following at any level of the CLI.
TurboIron#show ip bgp neighbor 10.192.168.4 routes unreachable
Syntax: show ip bgp neighbor routes unreachable
For information about the fields in this display, refer to Table 110 on page 751. The fields in this
display also appear in the show ip bgp display.
Displaying the Adj-RIB-Out for a neighbor
To display the Layer 3 Switch current BGP4 Routing Information Base (Adj-RIB-Out) for a specific
neighbor and a specific destination network, enter a command such as the following at any level of
the CLI.
The Adj-RIB-Out contains the routes that the Layer 3 Switch either has most recently sent to the
neighbor or is about to send to the neighbor.
Syntax: show ip bgp neighbor rib-out-routes [/]
For information about the fields in this display, refer to Table 110 on page 751. The fields in this
display also appear in the show ip bgp display.
Displaying peer group information
You can display configuration information for peer groups.
To display peer-group information, enter a command such as the following at the Privileged EXEC
level of the CLI.
TurboIron#show ip bgp neighbor 10.192.168.4 rib-out-routes 10.192.168.1/24
Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST I:IBGP L:LOCAL
Prefix Next Hop Metric LocPrf Weight Status
1 10.200.1.1/24 0.0.0.0 0 101 32768 BL