beautypg.com

Brocade TurboIron 24X Series Configuration Guide User Manual

Page 686

background image

652

Brocade TurboIron 24X Series Configuration Guide

53-1003053-01

Displaying OSPF information

Syntax: show ip ospf interface []

The parameter displays the OSPF interface information for the specified IP address.

The following table defines the highlighted fields shown in the above example output of the show ip
ospf interface command.

TABLE 100

Output of the show ip ospf interface command

This field

Displays

IP Address

The IP address of the interface.

OSPF state

ptr2ptr (point to point)

Pri

The link ID as defined in the router-LSA. This value can be one of the
following:

1 = point-to-point link

3 = point-to-point link with an assigned subnet

Cost

The configured output cost for the interface.

Options

OSPF Options (Bit7 - Bit0):

unused:1

opaque:1

summary:1

dont_propagate:1

nssa:1

multicast:1

externals:1

tos:1

Type

The area type, which can be one of the following:

Broadcast = 0x01

NBMA = 0x02

Point to Point = 0x03

Virtual Link = 0x04

Point to Multipoint = 0x05

TurboIron#show ip ospf interface 10.168.1.1

Ethernet 1,OSPF enabled

IP Address 10.168.1.1, Area 0

OSPF state ptr2ptr, Pri 1, Cost 1, Options 2, Type pt-2-pt Events 1

Timers(sec): Transit 1, Retrans 5, Hello 10, Dead 40

DR: Router ID 0.0.0.0 Interface Address 0.0.0.0

BDR: Router ID 0.0.0.0 Interface Address 0.0.0.0

Neighbor Count = 0, Adjacent Neighbor Count= 1

Neighbor: 10.2.2.2

Authentication-Key:None

MD5 Authentication: Key None, Key-Id None, Auth-change-wait-time 300