Displaying ip interface information – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 530
496
Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Displaying IP configuration information and statistics
When you specify how many seconds’ worth of statistics you want to display, the software selects
the sample that most closely matches the number of seconds you specified. In this example,
statistics are requested for the previous two seconds. The closest sample available is actually for
the previous 1 second plus 80 milliseconds.
Syntax: show process cpu [
The
parameter, the command lists the usage statistics only for the specified number of seconds. If you
do not use this parameter, the command lists the usage statistics for the previous one-second,
one-minute, five-minute, and fifteen-minute intervals.
Displaying IP interface information
To display IP interface information, enter the following command at any CLI level.
Syntax: show ip interface [ethernet [
This display shows the following information.
TABLE 76
CLI display of interface IP configuration information
This field...
Displays...
Interface
The type and the port number of the interface.
IP-Address
The IP address of the interface.
NOTE: If an “s” is listed following the address, this is a secondary address. When the address
was configured, the interface already had an IP address in the same subnet, so the
software required the “secondary” option before the software could add the interface.
OK?
Whether the IP address has been configured on the interface.
Method
Whether the IP address has been saved in NVRAM. If you have set the IP address for the
interface in the CLI, but have not saved the configuration, the entry for the interface in the
Method field is “manual”.
TurboIron#show process cpu 2
Statistics for last 1 sec and 80 ms
Process Name Sec(%) Time(ms)
ACL 0 0.00
ARP 1 0.01
BGP 0 0.00
DOT1X 0 0.00
ICMP 0 0.00
IP 0 0.00
L2VLAN 1 0.01
OSPF 0 0.00
RIP 0 0.00
STP 0 0.00
VRRP 0 0.00
TurboIron#show ip interface
Interface IP-Address OK? Method Status Protocol
Ethernet 1
10.95.6.173 YES NVRAM up up
Ethernet 2
10.3.3.3 YES manual up up
Loopback 1 10.2.3.4 YES NVRAM down down