Brocade TurboIron 24X Series Configuration Guide User Manual
Page 921

Brocade TurboIron 24X Series Configuration Guide
887
53-1003053-01
Displaying VRRP and VRRPE information
Syntax: show ip vrrp brief | ethernet
Syntax: show ip vrrp-extended brief | ethernet
The brief parameter displays summary information. Refer to
“Displaying summary information”
The
displays VRRP or VRRPE information only for the specified port.
The ve
displays VRRP or VRRPE information only for the specified virtual interface.
The stat parameter displays statistics. Refer to
This display shows the following information.
TABLE 137
CLI display of VRRP or VRRPE detailed information
This field...
Displays...
Total number of VRRP (or
VRRP-Extended) routers defined
The total number of VRIDs configured on this Layer 3 Switch.
NOTE: The total applies only to the protocol the Layer 3 Switch is running. For
example, if the Layer 3 Switch is running VRRPE, the total applies only
to VRRPE routers.
Interface parameters
Interface
The interface on which VRRP or VRRPE is configured. If VRRP or VRRPE is
configured on multiple interfaces, information for each interface is listed
separately.
auth-type
The authentication type enabled on the interface.
VRID parameters
VRID
The VRID configured on this interface. If multiple VRIDs are configured on the
interface, information for each VRID is listed separately.
TurboIron#show ip vrrp-extended
Total number of VRRP-Extended routers defined: 1
Interface ethernet 6
auth-type no authentication
VRID 1
state master
administrative-status enabled
priority 200
current priority 200
hello-interval 10000 msec
dead-interval 30000 msec
current dead-interval 30000 msec
preempt-mode true
virtual ip address 10.53.5.254
advertise backup: enabled
master router 10.53.5.2 expires in 00:00:03.0
track-port 4