Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 758)

732 Unified IP MIB Reference
53-1003106-01
General traps for the Brocade NetIron devices
67
snTrapOpticalMonitoringO
K
brcdIp.0.1214 snAgGblTrapMessag,
ifIndex Informational The SNMP trap is generated when an
interface transitions from an error state to
the normal state because the alarms or
warnings are below the threshold value. The
snTrapOpticalMonitoringError is generated
when the interface transitioned to the error
state.
The first varbind snAgGblTrapMessage, will
have a detailed message on the cause of
event. The second varbind ifIndex, points to
the affected interface that originates the
event. If an event does not have associated
port or has multiple associated ports, then
ifIndex has the maximum value 0x7ffffff.
snTrapSFMAccessOK
brcdIp.0.1215 snAgGblTrapMessage Informational The SNMP trap is generated when system
can successfully access an SFM Fabric
Element (FE).
The snTrapSFMAccessError is generated
when the system failed to access the FE.
snTrapUpgradeSingleCmd
Start
brcdIp.0.1216 snAgGblTrapMessage Informational The SNMP trap is generated when a
single-command package upgrade is
started. This happens after a successful
download and validation of the manifest file
and before the first image download takes
place.
snTrapUpgradeSingleCmd
Done
brcdIp.0.1217 snAgGblTrapMessage Informational The SNMP trap is generated when a
single-command package upgrade is
completed or partially completed. Refer to
brcdSwPackageLoadResultTable for the
results of the upgrade.
snTrapAutoUpgradeStart
brcdIp.0.1218 snAgentBrdIndex Informational The SNMP trap is generated when an
auto-upgrade on a line card is started.
snTrapAutoUpgradeDone
brcdIp.0.1219 snAgentBrdIndex,
snAgGblTrapMessage Informational The SNMP trap is generated when an
auto-upgrade of the interface module is
completed.
snTrapTcamParityError
brcdIp.0.1220 snAgentBrdIndex,
snAgGblTrapMessage Alerts The SNMP trap is generated when the TCAM
parity errors are detected on LP.
snTrapLPResetOnTcamErro
r
brcdIp.0.1221 snAgentBrdIndex,
snAgGblTrapMessage Critical The SNMP trap is generated when the LP
reset happens due to TCAM parity errors
crossing the threshold or TCAM integrity
check failure.
Trap name and number Varbinds Severity Description and trap message