Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 154)

128 Unified IP MIB Reference
53-1003106-01
Flash card
4
Flash card
The following objects manage the flash cards in all the devices.
snChasShutdownTemperat
ure
brcdIp.1.1.1.1.20
Syntax: Integer
NOTE: This object is
notsupported on
the Brocade MLXe,
Brocade NetIron
XMR, Brocade
NetIron MLX,
Brocade NetIron
CES, Brocade
NetIron CER series
and on the FastIron
devices. Instead
use
“System
temperature table”
on page 229.
Read/writ
e Applies only to management modules with temperature sensors.
Shows the temperature threshold that triggers the device to shut
down. When the actual temperature exceeds this value, the switch
shuts down a portion of the hardware to cool down the device. Each
unit is 0.5º Celsius.
Valid values: 0 – 250
NOTE: If you compare the value with the value while entering the show
chassis command and divide the value by 2. The result is the
warning (or shutdown) temperature. This is done intentionally
to represent the tenth decimal values in the SNMP, as the
SNMP can only report the INTEGER values.
snChasEnableTempWarnTr
ap
brcdIp.1.1.1.1.21
Syntax: Integer Read-write Indicates if the SNMP agent process has been enabled to generate
temperature warning traps:
•
disabled(0)
•
enabled(1)
Default: enabled(1)
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snChasFlashCard
brcdIp.1.1.1.1.22
Syntax: Integer32 Read-only Applies only to M4 management modules. This object is a bit array
that contains the flash card status.
This is a packed bit string. The status of each flash card is encoded
into one bit. There can be up to two flash cards.
The bits are:
•
2 to 31 – Reserved
•
1 – Flash card 2 status
•
0 – Flash card 1 status
(Bit 0 is the least significant bit.)
Flash card status can be one of the following:
•
0 – Flash card is absent
•
1 – Flash card is present
snChasFlashCardLeds
brcdIp.1.1.1.1.23
Syntax: Integer32 Read-only Shows the status of LEDs on a flash card. Each bit shows one of the
following:
•
0 – Flash card is off
•
1 – Flash card is on
snChasNumSlots
brcdIp.1.1.1.1.24
Syntax: Integer32 Read-only Shows the number of slots in the chassis.