Pim mib definition, Common pim objects, Snpimenable – Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) User Manual
Page 587: Snpimneighborroutertimeout, Chapter 55, Chapter
Unified IP MIB Reference
561
53-1003106-01
Chapter
55
PIM MIB Definition
In this chapter
•
•
•
•
•
Common PIM objects
NOTE
The following section describes the Protocol Independent Multicast (PIM) MIB objects that are
supported on the Unified IP MIB. The following objects are not supported on the Brocade NetIron
MLX, Brocade MLXe, Brocade NetIron XMR, Brocade NetIron CES, Brocade NetIron CER series and
Brocade FastIron devices.
The following table presents objects that are common to all PIM interfaces.
Name, OID, and syntax
Access
Description
snPimEnable
brcdIp.1.2.9.1.1
Syntax: RtrStatus
Read-write
Determines if PIM is enabled on this Layer 3 Switch:
•
disabled(0)
•
enabled(1)
Default: disabled(0)
The remaining objects apply only if this object is set to
enabled(1).
snPimNeighborRouterTimeout
brcdIp.1.2.9.1.2
Syntax: Integer
Read-write
Specifies the number of seconds the PIM Layer 3 Switch
waits before it considers a neighbor to be absent. Absence
of PIM hello messages from a neighboring Layer 3 Switch
indicates that a neighbor is not present.
Valid values: 60 – 8000 seconds
Default: 180 seconds