Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 712)

686 Unified IP MIB Reference
53-1003106-01
Standard traps
67
mplsL3VpnVrfNumVrfRouteM
axThreshExceeded
1.3.6.1.2.1.10.166.11.0.4 No mplsL3VpnVrfPerfCurrN
umRoutes,
mplsL3VpnVrfConfHigh
RteThresh This notification is generated when
the number of routes contained by the
specified VRF exceeds or attempts to
exceed the maximum allowed value as
indicated by
mplsL3VpnVrfMaxRouteThreshold. In
cases where
mplsL3VpnVrfConfHighRteThresh is
set to the same value as
mplsL3VpnVrfConfMaxRoutes,
mplsL3VpnVrfConfHighRteThresh
need not be exceeded; rather, just
reached for this notification to be
issued.
Note that the
mplsL3VpnVrfConfRteMxThrshTime
object denotes the interval at which
this notification will be reissued after
the maximum value has been
exceeded (or reached if
mplsL3VpnVrfConfMaxRoutes and
mplsL3VpnVrfConfHighRteThresh are
equal) and the initial notification has
been issued. This value is intended to
prevent continuous generation of
notifications by an agent in the event
that routes are continually added to a
VRF after it has reached its maximum
value. The default value is 0 minutes.
If this value is set to 0, the agent
should only issue a single notification
at the time that the maximum
threshold has been reached, and
should not issue any more
notifications until the value of routes
has fallen below the configured
threshold value.
mplsL3VpnNumVrfSecIllglLbl
ThrshExcd
1.3.6.1.2.1.10.166.11.0.5 No mplsL3VpnVrfSecIllegal
LblVltns This notification is generated when
the number of illegal label violations
on a VRF as indicated by
mplsL3VpnVrfSecIllegalLblVltns has
exceeded mplsL3VpnIllLblRcvThrsh.
The threshold is not included in the
varbind here because the value of
mplsL3VpnVrfSecIllegalLblVltns
should be one greater than the
threshold at the time this notification
is issued.
Trap name Supported? Varbind Description