Snipxsapfiltonallport, Snipxtxdroppktscnt, Snipxtxfiltpktscnt – Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) User Manual
Page 493: Ipx cache table, Snipxcachetable, Snipxcacheindex, Snipxcachenetnum, Snipxcachenode, Snipxcacheoutfilter
Unified IP MIB Reference
467
53-1003106-01
IPX cache table
48
IPX cache table
The IPX cache table contains information about the IPX forwarding cache for the router.
snIpxSapFiltOnAllPort
brcdIp.1.2.1.1.14
Syntax: Integer
Read-write
Applies the IPX RIP global filter list in the
object to
all interfaces. This object adds all filter lists and deletes all SAP filter
lists from all ports. Before sending this command, the
object must be defined.
The following values can be written:
•
deleteAllInBound(2) – Deletes all in-bound filter lists from all
ports.
•
deleteAllOutBound(3) – Deletes all out-bound filter lists from all
ports.
•
addAllInBound(4) – Adds all in-bound filter lists to all ports.
•
addAllOutBound(5) – Adds all out-bound filter lists to all ports.
The following values can be returned on reads:
•
noSuch(0) – Set operation has not be performed.
•
valid(1) – Set operation is done and is valid.
snIpxTxDropPktsCnt
brcdIp.1.2.1.1.15
Syntax: Counter
Read-only
Shows the number of packets that were queued to be sent on a port by
the Layer 3 Switch, but then dropped.
snIpxTxFiltPktsCnt
brcdIp.1.2.1.1.16
Syntax: Counter
Read-only
The number of packets that were queued to be sent on a port that
matched an outbound IPX filter that was configured on the port.
Name, OID, and syntax
Access
Description
Name, OID, and syntax
Access
Description
snIpxCacheTable
brcdIp.1.2.1.2.1
None
The IPX cache table.
snIpxCacheIndex
brcdIp.1.2.1.2.1.1.1
Syntax: Integer
Read-only The table index for an IPX cache table entry.
snIpxCacheNetNum
brcdIp.1.2.1.2.1.1.2
Syntax: NetNumber
Read-only Shows the network number containing the destination node.
snIpxCacheNode
brcdIp.1.2.1.2.1.1.3
Syntax: Physical address
Read-only Shows the number of the destination node.
snIpxCacheOutFilter
brcdIp.1.2.1.2.1.1.4
Syntax: Integer
Read-only Shows if an outbound cache filter has been enabled:
•
disabled(0)
•
enabled(1)