Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 36)

10 Unified IP MIB Reference
53-1003106-01
RFC 1493: Definitions of Managed Objects for Bridges
2
RFC 1493: Definitions of Managed Objects for Bridges
The following groups are supported on the Brocade NetIron and Brocade FastIron IC series devices.
NOTE
RFC 4188 obsoletes RFC 1493 on the Brocade NetIron XMR, Brocade NetIron MLX, Brocade MLXe,
Brocade NetIron CES, and Brocade NetIron CER series devices.
NOTE
The dot1dTpFdbTable (OID 1.3.6.1.2.1.17.4.4) in RFC 1493 is used to find dynamically learned MAC
addresses. Statically configured MAC addresses are in the snFdbTable (refer to
“Forwarding
database static table information” on page 323).
NOTE
The SNMP MIB object dot1dStpPortTable (OID 1.3.6.1.2.1.17.2.15) does not display information for
tagged ports that belong to an 802.1W RSTP configuration. The design of that MIB table is based
on a Single STP standard, and does not accommodate Multiple STPs. Thus, the table displays
information only for SSTP and for untagged ports.
NOTE
RFC 4188 has been converted to SMIv2 format. The object dot1dStpPortPathCost32 was added to
support IEEE 802. The existing MIB dot1dStpPortPathCost has an upper range of 65535. Over that
value, this MIB stays at the upper value and you should access dot1dStpPortPathCost32, which has
a higher upper-range value.
RFC 1757: Remote Network Monitoring Management
Information Base
The following groups from this RFC are supported on NetIron devices.
NOTE
This RFC is obsolete and is replaced by RFC 2819 for the Brocade NetIron XMR, Brocade NetIron
MLX, Brocade MLXe, Brocade NetIron CES, and Brocade NetIron CER series devices.
Object group name Object identifier
dot1dBridge 1.3.6.1.2.1.17
dot1dBase 1.3.6.1.2.1.17.1
dot1dStp 1.3.6.1.2.1.17.2
dot1dTp 1.3.6.1.2.1.17.4