Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 633)

Unified IP MIB Reference 607
53-1003106-01
Chapter
61
MPLS Layer2 VPN MIB Definition
In this chapter
• VLL endpoint table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 607
• VPLS endpoint2 table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 608
• VPLS instance table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 609
• VPLS MAC age timer configuration scalar objects . . . . . . . . . . . . . . . . . . . 610
This chapter describes the MIB objects for the Virtual Local Area Network (VLAN) extended
statistics supported on G2 products of Brocade MLX series and Brocade NetIron XMR devices.
Use the extended-counters priority command to configure a module to enable per VLAN port, or
priority accounting (or extended counters) that applies to both ingress and egress counters. Use
the extended-counters routed-switched command to configure the system to count switched and
routed packets separately. All the counters reset to “0” when the state is changed. For more
information, refer to the Brocade MLXe and NetIron Family Configuration Guide.
NOTE
The Layer 2 VPN counters apply only to switched packets.
VLL endpoint table
The following table (fdryVllEndPointTable) contains objects for VLL and VLL-local endpoints that are
not available in the pseudo Wire MIB.
NOTE
Use the snmp-server disable mib mib-table-keyword command to disable the SNMP support for the
table and use the no form of the command to re-enable the support. The overall SNMP-WALK
performance is increased when the SNMP support is disabled for the table.
Name, OID, and syntax Access Description
pwIndex
brcdIp.3.1.2.1.1
Syntax: pwIndexType None pwIndex of pwTable and pwEnetTable (foreign index)
pwEnetPwInstance
brcdIp.3.1.4.1.1.1.1
Syntax: Unsigned32 None The second index of pwEnetTable (foreign index) to support
VLL-local:
•
VLL - 1
•
vlllocal - 1 and 2
fdryVllEndPointServiceType
brcdIp.1.2.15.2.1.1.1.1
Syntax: Integer None Indicates the service type for the endpoint:
•
vll(1)
•
vlllocal(2)