Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 540)

514 Unified IP MIB Reference
53-1003106-01
OSPF interface configuration tables
50
OSPF interface 2 configuration table
The following table replaces snOspfIfTable and snOspfIf2Port is an ifIndex of the table.
snOspfIfMd5ActivationWaitTime
brcdIp.1.2.4.4.1.1.15
Syntax: Integer Read-write Determines when a newly configured MD5 authentication key
is valid. This parameter provides a graceful transition from one
MD5 key to another without disturbing the network. All new
packets transmitted after the key activation wait time interval
use the newly configured MD5 key. OSPF packets that contain
the old MD5 key are accepted for up to five minutes after the
new MD5 key is in operation. The range for the key activation
wait time is from 0 through 14400 seconds.
Default: 300 seconds
snOspfIfAreaIdFormat
brcdIp.1.2.4.4.1.1.16
Syntax: Integer Read-only Specifies the format of how Area ID will be entered in the
“snOspfIfAreaId” object:
•
integer(0) – Integer
•
ipAddress(1) – IP Address
snOspfIfPassiveMode
brcdIp.1.2.4.4.1.1.17
Syntax: Integer Read-write Indicates if passive mode is enabled on this interface:
•
disabled(0)
•
enabled(1)
snOspfIfDatabaseFilterAllOut
brcdIp.1.2.4.4.1.1.18
Syntax: Integer Read-write Determines if the filtering of an outgoing OSPF LSA on this
interface is enabled:
•
disabled(0) – Filtering is disabled.
•
enabled(1) – Filtering is enabled.
snOspfIfMtuIgnore
brcdIp.1.2.4.4.1.1.19
Syntax: Integer Read-write Determines if the MTU detection mode of this interface is
enabled:
•
disabled(0) – MTU detection mode is disabled.
•
enabled(1) – MTU detection mode is enabled.
snOspfIfNetworkP2mp
brcdIp.1.2.4.4.1.1.20
Syntax: Integer Read-write Determines if the P2MP mode of this interface is enabled:
•
disabled(0) – P2MP mode is disabled.
•
enabled(1) – P2MP mode is enabled.
Name, OID, and syntax Access Description
snOspfIf2Table
brcdIp.1.2.4.4.2 None The OSPF interface table describes the interfaces from the
viewpoint of OSPF.
Determines if the P2MP mode of this interface is enabled:
•
disabled(0) – P2MP mode is disabled.
•
enabled(1) – P2MP mode is enabled.
snOspfIf2Port
brcdIp.1.2.4.4.2.1.1
Syntax: Integer32 Read-only The physical router port of this OSPF interface.
snOspfIf2AreaId
brcdIp.1.2.4.4.2.1.2
Syntax: AreaID Read-write Specifies the address of the area in a 32-bit integer. This
address uniquely identifies the area to which the interface
connects. Area ID 0.0.0.0 is used for the OSPF backbone.
Default: ’00000000’h, which is equal to 0.0.0.0
Name, OID, and syntax Access Description