Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 470)

444 Unified IP MIB Reference
53-1003106-01
VSRP virtual router table
44
snVsrpVirRtrRxNumOfIp
MismatchCnts
brcdIp.1.1.3.21.3.1.1.24
Syntax: Counter32 Read-only Shows the received number of mismatched IP addresses for VSRP.
snVsrpVirRtrRxIpMismat
chCnts
brcdIp.1.1.3.21.3.1.1.25
Syntax: Counter32 Read-only Shows the number of received VSRP IP addresses that are
mismatched.
snVsrpVirRtrRxHelloIntM
ismatchCnts
brcdIp.1.1.3.21.3.1.1.26
Syntax: Counter32 Read-only Shows the number of the virtual router interfaces with hello intervals
that are mismatched.
snVsrpVirRtrRxPriorityZe
roFromMasterCnts
brcdIp.1.1.3.21.3.1.1.27
Syntax: Counter32 Read-only Shows the number of advertisements with priority of zero received
from the master.
snVsrpVirRtrRxHigherPri
orityCnts
brcdIp.1.1.3.21.3.1.1.28
Syntax: Counter32 Read-only The counts of the virtual router interfaces with higher priority.
snVsrpVirRtrTransToMas
terStateCnts
brcdIp.1.1.3.21.3.1.1.29
Syntax: Counter32 Read-only Shows the number of times this interface has changed from the
master state to the backup state for the VRID.
snVsrpVirRtrTransToBac
kupStateCnts
brcdIp.1.1.3.21.3.1.1.30
Syntax: Counter32 Read-only Shows the number of times this interface has changed from the
master state to the backup state.
snVsrpVirRtrCurrDeadInt
brcdIp.1.1.3.21.3.1.1.31
Syntax: Integer32 Read-only Shows the current dead intervals in increments of 100 milliseconds for
the virtual router. This is the time period that a backup waits for a hello
message from the master before determining that the master is no
longer active. If the master does not send a hello message before the
dead interval expires and the backups negotiate (compare priorities) to
select a new master.
snVsrpVirRtrCurHelloInt
brcdIp.1.1.3.21.3.1.1.32
Syntax: Integer Read-only Shows the current backup router hello interval.
snVsrpVirRtrCurHoldDo
wnInt
brcdIp.1.1.3.21.3.1.1.33
Syntax: Integer Read-only Shows the current value of the hold-down interval.
Valid values: 1 - 84
snVsrpVirRtrCurInitTtl
brcdIp.1.1.3.21.3.1.1.34
Syntax: Integer Read-only Shows the current TTL value.
Valid values: 1 - 255
Name, OID, and syntax Access Description