Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 376)

350 Unified IP MIB Reference
53-1003106-01
802.1X port configuration table
30
802.1X port configuration table
The following table contains configuration parameters specific to interfaces. The information in this
table is equivalent to the output of the following CLI commands:
• show dot1x port-control auto
• show dot1x port-control force-authorized
• show dot1x port-control force-unauthorized
• show dot1x configuration ethernet port
802.1x port state table
The following table contains the port-specific parameters indicating the dynamic state that the
interface is in. The information in this table is equivalent to the information in the output of the
show dot1x configuration port command.
brcdDot1xAuthPortStatRx
LengthErrorFrame
brcdIp.1.1.3.38.2.1.1.10
Syntax: Integer32 Read-only The length of the EAP error frame received.
brcdDot1xAuthPortStatTx
RequestFrames
brcdIp.1.1.3.38.2.1.1.11
Syntax: Counter32 Read-only The number of transmitted EAP request frames on the port.
brcdDot1xAuthPortStatLa
stEAPFrameSource
brcdIp.1.1.3.38.2.1.1.12
Syntax: MacAddress Read-only The MAC address of the source from which the last EAP frame was
received.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
brcdDot1xAuthPortConfig
PortControl
brcdIp.1.1.3.38.3.1.1.1
Syntax: Integer Read-write The control type configured for the interface:
•
forceUnauthorized(1) - The controlled port is placed.
unconditionally in the unauthorized state.
•
controlauto(2) - The controlled port is unauthorized until
authentication takes place between the client and the RADIUS
server.
•
forceAuthorized(3) - The controlled port is placed unconditionally
in the authorized state.
brcdDot1xAuthPortConfig
FilterStrictSec
brcdIp.1.1.3.38.3.1.1.2
Syntax: EnabledStatus Read-write Enables or disables filter strict security on the interface:
•
enabled(1)
•
disabled(2)
brcdDot1xAuthPortConfig
Dot1xOnPort
brcdIp.1.1.3.38.3.1.1.3
Syntax: EnabledStatus Read-write Enables or disables 802.1x on an interface.