Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 451)

Unified IP MIB Reference 425
53-1003106-01
VRRP virtual router table
42
snVrrpVirRtrRxHelloIntMism
atchCnts
brcdIp.1.2.12.3.1.1.21
Syntax: Counter32 Read-only Shows the number of packets received that did not match the
configured hello interval.
snVrrpVirRtrRxPriorityZeroFr
omMasterCnts
brcdIp.1.2.12.3.1.1.22
Syntax: Counter32 Read-only Shows the counts of the virtual router interface with priority zero from
the master.
snVrrpVirRtrRxHigherPriority
Cnts
brcdIp.1.2.12.3.1.1.23
Syntax: Counter32 Read-only Shows the number of VRRP packets received by the interface that had
a higher backup priority for the VRID than what this interface’s backup
priority is.
snVrrpVirRtrTransToMasterS
tateCnts
brcdIp.1.2.12.3.1.1.24
Syntax: Counter32 Read-only Shows the number of times this interface has changed from the
backup state to the master state for the VRID.
snVrrpVirRtrTransToBackupS
tateCnts
brcdIp.1.2.12.3.1.1.25
Syntax: Counter32 Read-only Shows the number of times this interface has changed from the
master state to the backup state for the VRID.
snVrrpVirRtrCurrDeadInt
brcdIp.1.2.12.3.1.1.26
Syntax: Integer32 Read-only Shows the number of seconds a backup waits for a hello message
from the master before determining that the master is no longer
active. If the master does not send a hello message before the dead
interval expires, the backups negotiate (compare priorities) to select a
new master.
snVrrpVirRtrTrackPortList
brcdIp.1.2.12.3.1.1.27
Syntax: OCTET STRING Read-write This object specifies the identity of the physical port whose state is to
be monitored.
Each port index is a 16-bit integer in big-endian order. The first 8 bits
are the slot number; the next 8 bits are the port number. Default
value is 0 length octet string.
If this object is configured on an interface, then the preference level
for the interface will be adjusted dynamically, depending on the state
of the track port:
•
When the track port state first changes from up to down, the
interface’s preference level is reduced by the value of the
preference level parameter.
•
The next time the track port state changes from down to up, the
interface’s preference level is increased by the amount specified
by the preference level.
snVrrpVirRtrTrackVifPortList
brcdIp.1.2.12.3.1.1.28
Syntax: OCTET STRING Read-write This object specifies the identity of the virtual interface whose state is
to be monitored.
Each port index is a 16-bit integer in big-endian order. The first 8 bits
are the slot number; the next 8 bits are the port number. Default
value is 0 length octet string.
If this object is configured on an interface, then the preference level
for the interface will be adjusted dynamically, depending on the state
of the track port:
Name, OID, and syntax Access Description