Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 448)

422 Unified IP MIB Reference
53-1003106-01
VRRP virtual router table
42
Name, OID, and syntax Access Description
snVrrpVirRtrTable
brcdIp.1.2.12.3.1 None The VRRP virtual router table.
snVrrpVirRtrPort
brcdIp.1.2.12.3.1.1.1
Syntax: Integer32 Read-only Shows the port number of this VRRP interface.
snVrrpVirRtrId
brcdIp.1.2.12.3.1.1.2
Syntax: Integer Read-only Shows the VRID that has been configured on this interface. If multiple
VRIDs are configured, there is an entry for each VRID.
snVrrpVirRtrOwnership
brcdIp.1.2.12.3.1.1.3
Syntax: Integer Read-write Indicates the owner of the router interface. The owner or master
router owns the IP addresses associated with the VRID:
•
incomplete(0) – No IP address has been assigned to this VRRP
router interface.
•
owner(1) – The owner or the master router is the owner of the
VRRP router interface.
•
backup(2) – The backup router is the owner of the interface.
snVrrpVirRtrCfgPriority
brcdIp.1.2.12.3.1.1.4
Syntax: Integer Read-write Applies only if the “snVrrpVirRtrOwnership” object is set to backup(2).
It indicates the backup router’s preferability to becoming the active
router for the interface. The higher the number, the higher the priority.
If two or more devices are tied with the highest priority, the backup
interface with the highest IP address becomes the active router for
the VRID.
Valid values: 3 – 254
Default: 100
snVrrpVirRtrTrackPriority
brcdIp.1.2.12.3.1.1.5
Syntax: Integer Read-write Applies to interfaces that are configured with track ports.
It indicates the priority of the track ports. A higher number indicates a
higher priority. Track port priority is always lower than the
“snVrrpVirRtrCfgPriority” priority.
This object is adjusted dynamically with the “snVrrpVirRtrCurrPriority”
object when the track port state first changes from up to down.
Valid values: 1 – 254
snVrrpVirRtrCurrPriority
brcdIp.1.2.12.3.1.1.6
Syntax: Integer Read-only The current VRRP priority of this Layer 3 Switch for the VRID. The
current priority can differ from the configured priority for the following
reasons:
•
The VRID is still in the initialization stage and has not yet become
a master or backup. In this case, the current priority is 0.
•
The VRID is configured with track ports and the link on a tracked
interface has gone down.
A higher number indicates a higher priority.
This object is adjusted dynamically with the
“snVrrpVirRtrTrackPriority” object.
Valid values: 1 – 254
snVrrpVirRtrHelloInt
brcdIp.1.2.12.3.1.1.7
Syntax: Integer Read-write Shows the number of seconds between hello messages that are sent
between the master and the backup.
Valid values: 1 – 84 seconds
Default: 1 second