Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 234)

208 Unified IP MIB Reference
53-1003106-01
Switch port information
8
snSwIfStatsInUtilization
brcdIp.1.1.3.3.5.1.52
Syntax: Integer
NOTE: This object is
supported on the
Brocade MLXe,
Brocade NetIron
MLX, Brocade
NetIron XMR,
Brocade NetIron
CES, Brocade
NetIron CER
series devices.
Read-only Indentifies the input network utilization in hundredths of a percent over a
five-minute interval.
Valid values: 0 – 10000
snSwIfStatsOutUtilization
brcdIp.1.1.3.3.5.1.53
Syntax: Integer
NOTE: This object is
supported on the
Brocade MLXe,
Brocade NetIron
MLX, Brocade
NetIron XMR,
Brocade NetIron
CES, Brocade
NetIron CER
series devices.
Read-only Shows the output network utilization in hundredths of a percent over a
five-minute interval.
Valid values: 0 – 10000
NOTE: Ethernet devices must allow a minimum idle period between transmission of frames known as interframe
gap (IFG) or interpacket gap (IPG). The gap provides a brief recovery time between frames to allow devices
to prepare to receive the next frame. The minimum IFG is 96 bit times, which is 9.6 microseconds for 10
Mbps Ethernet, 960 nanoseconds for 100 Mbps Ethernet, and 96 nanoseconds for 1 Gbps Ethernet. In
addition, to account for the bit rate on the port, port utilization should also account for the IFG, which
normally is filtered by the packet synchronization circuitry.
Refer to the etherHistoryUtilization objects in the RFC 1757: Remote Network Monitoring Management
Information Base for details.
snSwIfStatsInKiloBitsPer
Sec
brcdIp.1.1.3.3.5.1.54
Syntax: Unsigned32
NOTE: This object is
supported on the
Brocade MLXe,
Brocade NetIron
MLX, Brocade
NetIron XMR,
Brocade NetIron
CES, Brocade
NetIron CER
series devices.
Read-only Shows the bit rate, in kilobits per second, received on a 10 Gigabit or
faster interface within a five-minute interval.
Name, OID, and syntax Access Description