Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 168)

142 Unified IP MIB Reference
53-1003106-01
Usage notes on CPU utilization and system CPU utility table
5
The none option instructs the device to ignore the value of snAgGblPassword and the
authentication check will always pass. You can enter the following SNMP command to use this
method.
SnmpSet(snAgGblPassword.0="", snAgEraseNVRAM.0=3)
aaa authentication login default TACACS+
aaa authentication enable default TACACS+
aaa authentication enable implicit-user
The snAgGblPassword object must be set for the following objects:
• snAgCfgLoad
• snAgImgLoad
• snAgConfigFromNVRAM
• snAgEraseNVRAM
• snAgWriteNVRAM
• snAgGblTelnetPassword
• snAgReload
• snAgSystemLog
Usage notes on CPU utilization and system CPU utility table
There are three groups of CPU utilization MIB objects.
Group A consists of the following object and it is not to be used.
The object in this group can display management module CPU utilization. The data it displays is
from the last time that this object was read. If there is more than one management station reading
the object, conflict occurs because every read resets the CPU utilization until the next read. It is
recommended that this object not to be used.
Group B consists of the following objects.
Group B was created to resolve the multi-management stations issue of snAgGblCpuUtilData.
These three objects are time-based. However, they only work for the management CPU utilization.
NOTE
The objects in Group B have been obsoleted on the Brocade NetIron XMR and Brocade NetIron MLX
devices.
Use snAgentCpuUtilTable on the Brocade NetIron XMR and Brocade NetIron MLX devices.
MIB object OID
snAgGblCpuUtilData brcdIp.1.1.2.1.35
MIB object OID
snAgGblCpuUtil1SecAvg brcdIp.1.1.2.1.50
snAgGblCpuUtil5SecAvg brcdIp.1.1.2.1.51
snAgGblCpuUtil1MinAvg brcdIp.1.1.2.1.52