Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 216)

190 Unified IP MIB Reference
53-1003106-01
Switch group configuration
7
snSwIpxL3SwMode
brcdIp.1.1.3.1.28
Syntax: Integer Read-write Indicates whether or not Layer 3 IPX switch mode is enabled:
•
disabled(0)
•
enabled(1)
Default: disabled(0)
snVLanByIpSubnetMaxSub
nets
brcdIp.1.1.3.1.29
Syntax: Integer32
NOTE: This object is not
supported on the
Brocade MLXe,
Brocade NetIron
MLX, Brocade
NetIron XMR,
Brocade NetIron
CES, and Brocade
NetIron CER series
devices.
Read-only Shows the maximum number of subnets for each IP VLAN.
snVLanByIpxNetMaxNetwor
ks
brcdIp.1.1.3.1.30
Syntax: Integer32
NOTE: This object is not
supported on the
Brocade MLXe,
Brocade NetIron
MLX, Brocade
NetIron XMR,
Brocade NetIron
CES, and Brocade
NetIron CER series
devices.
Read-only Shows the maximum number of networks for each IPX VLAN.
snSwProtocolVLanMode
brcdIp.1.1.3.1.31
Syntax: Integer Read-write Indicates whether or not protocol VLAN is enabled:
•
disabled(0)
•
enabled(1)
snMacStationVLanId
brcdIp.1.1.3.1.32
Syntax: Integer Read-write Shows the MAC Station’s VLAN ID index in the standard Forwarding
Database for Transparent Bridge Table (dot1dTpFdbTable). Because
the dot1dTpFdbTable index is the MAC address assigned to one of the
ports in the bridge (VLAN) and each MAC address can be re-assigned
to different ports belonging to different bridges (VLANs), the
snMacStationVLanId can be used to specify which bridge (VLAN) MAC
Station information of the dot1dTpFdbTable to retrieve. If you do not
specify the VLAN ID in this MIB, the default VLAN (bridge) ID will be
used when dot1dTpFdbTable is retrieved.
Valid values: 1 – 4095
snSwClearCounters
brcdIp.1.1.3.1.33
Syntax: Integer Read-write Clears software counters:
•
valid(0) – An SNMP-GET of this MIB shows that it is a valid
command to use.
•
clear(1) – Clear counter commands of the following counters:
Dot3, MIB2, IP, and IPX counters for all ports.
Name, OID, and syntax Access Description